Enter 0,0in all directions (figure 2):

    Figure 2: Move Dialog

    Go to the Modify Panel and change the proportions of the plane to 200 units long x 100 units wide (figure 3).

    Figure 3: Modify Panel Button

    Open the Material Editor (keyboard shortcut: [m]), and rename the first material to PDA_picture.

    Apply the bitmap ‘PDA_front.tif’ as diffuse color map (figure 4).

    Figure 4: PDA_front.tif  Assign the material to the plane and click Show Map in Viewport in the Material Editor (figure 5):

    Figure 5: Show map button

    The result should look like this (figure 6):

    1.移动图标

    从各方位进入0.0（见2.）

    2.移动对话框

    进入Modify Pane，将平面的长宽比例改为200X100（见3.）

    3.修改平面图标

    打开Material Editor（快捷键[m]），重命名第一个材料至PDA图片。应用PDA_front.tif位图作为散播的色彩图。（见4.）

    4.PDA_front.tif 位图

    添加指令，把材料放入平面，进入Material Editor中的Viewport，点击Show Map。（见5.）

    5.Show map图标

    您可以看到如下设置：

    Figure 6: Plane with map

    Freeze the plane by right clicking it select Properties from the popup menu. Uncheck ‘Show Frozen in Grey’and check ‘Freeze’. Click ‘OK’. This way you won’t select the plane by mistake.Make a box covering the entire PDA on the picture, apart from the antenna. Make the height of the box 10,0.Rename the box: PDA.Right click the box and choose Properties from the popup menu. Check ‘See-Through’.

    6.带图平面

    右击锁定平面,从弹出的菜单中选中Properties. 除去Show Frozen in Grey处的勾,并在Freeze处打勾,这样能够避免误选平面.用一个10.0高（除去天线的部分）的框遮住图片中整个PDA的部分，把框重命名为PDA，右击该框，从弹出的菜单中选择Properties，在See-Through处打勾。

    Turn on Edged Faces in the perspective viewport by right clicking in the top left hand corner of the viewport and select ‘Edged Faces’ from the popup menu.This enables you to get a better overview of the diVisions of the mesh.

    Right click the box and select ‘Convert To: > Convert to Editable Poly’.

    In the Modify Panel under Selection, choose subobject ‘Edge’ (keyboard shortcut [2]).

    右击左上角的viewport,在透视角度中开启Edged Faces，从弹出的菜单中选择‘Edged Faces’，这能使您更清楚地看到网络分布图的概貌。右击该窗并选择‘Convert To: > Convert to Editable Poly‘，在Selection下的Modify Panel中选择子对象‘Edge’（快捷键[2]）

    Figure 7: Subobject 'Edge' Button

    Select the four edges lengthwise on the box, and click Connect Option box in the Modify Panel (figure 8).

    7. 子对象‘Edge’键

    选择纵向框内的四个Edge，在Modify Panel中点击Connect Option box（步骤8）

    Figure 8: Connect Button

    Set ‘Connect Edge Segments’ to 2 and click OK (figure 9).

    8. Connect键

    把‘Connect Edge Segments’设置到2，点击OK （步骤9）

    Figure 9: Connect Edges Dialog

    This will add more faces to the